Repair And Restoration
TO ADD FORUM POST USE THE DISCUSSIONS TAB OR ADD NEW TOPIC IN THE SIDE BAR
Organizer:
- Organized by
-
-
Detached Wiring – Wire Hanger Enhancement
-
Detached Wiring – Wire Hanger Enhancement
Hi Everyone,
I hope everyone is having a great weekend!
I have some wiring that has come loose in an acoustic guitar as the adhesive attached to the wire hangers has failed after about 1.5-2 years.
Normally I would just pop in new ones but I’m wondering if there is a stronger adhesive that can be added instead of just relying on the sticky tape that comes with what is in the included pictures.
Thanks in advance!
-
7 Replies
-
If I remember correctly, I think Evan puts a small dot of thick CA glue on those to ensure a longer lasting bond. Great idea! I always forget. I’ve been using those for decades and if the wood is clean, they can stick really, really good on their own. Whenever I see them fall off there’s always some dust, wood chips, tone balls or something preventing good adhesion.
-
+1 We did that at Breedlove for all Fishman installs.
-
Should I remove the existing adhesive sticker/tape or just put the thick CA glue right on top of it?
-
We did right on top. You could also wipe the spot with a little naphtha. Doesn’t hurt.
-
Thanks again!
-
-
-
-
I have used 3M VHB (Very High Bonding) tape in similar situations with no failure. Its a bit pricey, but only used in small bits.
-
Great suggestion!
Thank you!
-
Log in to reply.