[Bill Henry]

Agreed, I just wanted to male aure this wasn’t a question for profiling. Like Jazz on the juke box in Taledega Nights 😊

I will take a run at it, and pass along if successful. I use Sketchup, need to get in the Fusion train.

[Bill Henry]

Just finished first attempt at a neck shim. This is 1 degree, solid infill.

I will post, and work on 1/2 and 1/4 degree as well. Change fill to 100, and must be rectilinear.

[Bill Henry]

Electric,

I wondered if a solid infill would be acceptable.

[Bill Henry]

Good call, I expect that will eliminate the layer lines to make the angle.

I will try that, and once improved, will do other degrees as well.