Hello!

I have an Ovation CP-100 pickup. Its unsoldered and I can’t seem to get the pickup to work again.

There wasn’t a spacer either. Which doesn’t make sense because if the hot is soldered to the copper strip and the ground to the housing channel, it would just ground out.

Any experience getting these back together?…

Read more

Ok. I am stumped.

PRS Studio is in. 3 pickups. 5-way selector switch. 2 pots.

Here’s the dilemma:

Customer wants two concentric pots installed.

The front pot would be volume for the neck & middle pickups on the top knob, the bridge volume bottom knob.

The rear knob is for tone. Top knob controls neck & middle pickups tone, bottom controls the…

Read more

Could not find any details, but does anyone know which value pots are used with the PRS Narrowfield pickups?

Or alternately, anyone have any opinions on them?

thanks.

Ok. Did a refret on a MIM Fender Strat maple neck. Some of the finish came off (was careful AF but….)

It is not lacquer but I assume a poly finish. New lacquer did not meld.

Can/should I use a tinted CA fix? Any tips, color recipes?

Any help would be appreciated. VERY appreciated.

Thanks

-Mike