Bryan
Forum Replies Created
-
Yes
-
After fiddling with it for a while, i’ve found that the middle pickup seems to be the culprit. when its connected via the push pull, whether its pulled up or left down, it kills the total output of the entire guitar.
-
Hey, I just wanted to follow up with this and say thank you! I’ve got it wired up now and it seems to work out just how I wanted it! I have run into an issue though that I didn’t expect. The bridge pickup is very quiet. I’m honestly not sure what to do, I’ve tested the pickups on a multimeter, and it read as id expected.
-
The way i’m understanding it currently is as follows.
1 500k Tone pot, 1 500k Push/pull volume pot, 1 3-way selector. Looking back, i’m guessing the toggle is omitted here in favor of the push/pull. Pickups are wired to the pot first, then selector, then straight to the output(?). Then when the volume knob is pulled up, it “turns on” the middle pickup. How/where would I put a resistor to get the bridge and middle pickups here to “see” the 500k as 250k instead. Apologies if the questions are a bit much, i’m very new at messing with the wiring in my guitar, and am used to just following diagrams for pickups swaps. This is my first venture into trying something new. -
So im having a bit of trouble visualizing this, apologies. If I were to use a push pull, then I could stick with having just 2 pots, a master volume and tone? How would this work in practice with the toggle, would pulling up the pot/knob turn on the pickup, or the toggle?
