I wasn’t familiar with the loothalong, thanks! I *think* I have figured it out, first checking for mystery bumps/undercutting further and using sidewise flossing (we need better names for this!) on the purple tape side and base of the neck.

If I don’t get it in an hour or so, then I’ll jump into the loothalong. Thanks Ian and Pete for putting…

Read more

This is helpful, but I’m not sure what my next step is. As far as I can tell, the neck is exactly where I want it from the pitch, string alignment and elevation. But I also have the .035” gap.

So not sure where I should target to close that gap without making everything else that is correct not be worse

I don’t think the other two did make it into the repository, but in my case, once I have the support in place I can imagine how those template pieces should work.

If I model them myself, I’ll share them here

@jmstewartguitars This looks like a pretty trivial print, so I’ll try and build it this week and post back. If it’s an obvious success, I’ll print the parts for you also. It won’t be expensive, the design doesn’t use much filament

Can you link to the file? I have a 3D printer and could use this jig, would be happy to print one for myself and if successful, print one for you also