Ian Davlin The Looth Group
-
Ben Gormly Amateur builder, Fred and Brandon Forsyth Fret Tec, LLC1 Comment-
Oh nice, it’s Red Wing! I spent a summer there with Stoney End Harps and probably should have stuck around and gone to this school.
-
-
https://www.tomshardware.com/3d-printing/philips-debuts-3d-printable-components-to-repair-products
tomshardware.com
Philips debuts 3D printable components to repair products
No more rigging your own fixes, download the official part.
Matt Fagan B.M. Fagan Guitars LLC and Brandon Forsyth Fret Tec, LLC -
Pin Puller V2A simple 3D print to turn the Stewmac Fret Pullers into Bridge Pin pullers. Great way to get more use out of an expensive too.
-
-
Ask Roadman about his, I think he has 3 different ones 🤓
-
-
Reply to Los Angeles Area Looth to take on Martin Neck reset
Im going to make sure this gets into the next news letter. In the meantime, have you looked at the loothmap ?
-
Reply to "Angle, center, elevation"...how to close this gap in the neck?
This might be easier to look at online. Have you been on the loothalong ?
-
Reply to "Angle, center, elevation"...how to close this gap in the neck?
One thing to check when getting mystery gaps is that there is a gap between the face of the mortise side and the tenon side. Since you cant see inside the joint when the neck is in, you can check it by chalking one side.
-
-
Gypsy Guitars: Jacques Mazzoleni with Carl MeineCarl interviews Jacques Mazzoleni: historian, curator, seller and keeper of the gypsy guitar tradition. The discussants just couldn’t wait to get started on this one,…
-
- Load More
